Easicoat EC-5340 Adhesion Promoter
$0
AUXILIARY PRODUCTS:
EC-5340 Adhesion Promoter
SUBSTRATES:
Plastic parts PP, PA, PE
SURFACE PREPARATION:
Wet sanding: Sanding with P800-P1000,
remove wax, silicon or other contaminations
with 5910 degreaser.
Dry sanding: Sanding with cleaner.
MIXING RATIO:
Packaged ready to use
APPLICATION:
Spray gun set up and pressure:
RP： 1.3mm 29-36psi
HVLP：1.3mm 26-29psi
Please refer to gun manufacturer for proper spray pressure
recommendations.
Coats & Thickness:
1-2 Coats, 4-5μm
Flash off time: 3-5 mins. between
coats @ 73° F
Air drying time: allow 5-10 mins. @ 73° F
Descripción
CLEARNING:
Clean equipment immediately with solvent after application
PHYSICAL DATA:
VOC: 7.0 lbs/gal
FOR PROFESSIONAL USE ONLY
Read MSDS Before Use
NOTE: The information in this data sheet is based on our knowledge
and the current laws. It is always the responsibility of the user to fulfill
the requirements of local rules and legislations. The uncertain factors
may affect the application of products, such as the condition of
substrate. We do not accept any liability on loss, damage and
performance of products unless we issue a special agreement.
Always read the latest Material Data Sheet and the Technical Data
sheet before applying the products.
Valoraciones
No hay valoraciones aún.